AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1,007 Posts
Discussion Starter #1
Hi I am redoing my setup from scratch. I have the installation screen looking sharp.


First


a) My grids DOES NOT look like a square when the projector in laying flat. They are thin on the bottom and wide up top.

Any suggestions.


b) I have read posts where the screen distance calculations from barco may be wrong. When I follow then the installation grids are much bigger than the screen. Is this true and if so Whats the best measurement.


Thanks
 

·
Registered
Joined
·
1,216 Posts
You should do all your alignment and mechanical convergence using your actual source and a setup DVD like AVIA. Barco's built-in patterns are made to fill up the raster.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top