AVS Forum banner

Blackout Cloth Screen for BenQ W1070

2K views 5 replies 2 participants last post by  thadius65 

Quote:
Originally Posted by thadius65  /t/1517604/blackout-cloth-screen-for-benq-w1070#post_24353651


I fear I have asked to many questions??

Naw...just a tad impatient.


Staple in the front, but double up you staples at every point, and pull the BOC as tight as you can opposite each previous staple point.


You'll have to count on the extra material length to get your most tension, but you have to get "Top to Bottom" tension right first.

You made thing more difficult by opting for just 110" wide BOC. You have no other option but to build a Frame that is 110" x 63"


Felt tape over Pulled BOC and staples?


Good luck with that. Sounds like it's gonna be a bit rough looking.Better to use 1/2" x 2" MDF Trim covered in 3" Tape....or better still Black Velvet, and tacked into place using 1.25" Finish Nails.


The latter far better at salvaging a problematical build, and giving you something to crow about.


Asking lots of questions......a good thing to do.


Following good advice....priceless.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top