AVS Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter · #1 ·
Hi, I noticed that when I play a bluray in PowerDVD 9 about every 20 minutes, or even sooner sometimes, the picture pauses for a couple of seconds and skips to the point where it should have been. The audio continues to play while this happens. Is this a problem with the software or should I check a different setting?


Also, since I have a clarkdale with the intel graphics control panel, is the proper way to set the bluray output to 24p to change the refresh rate in the control panel to 24Hz?


Thanks
 
1 - 1 of 1 Posts
Top