AVS Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #1 ·
Help. My off button hasn't been working for a while but it's really no big deal. But when I was converging the other night, my ADJ G button, and then my Input A button failed. What's wrong? BTW - I don't have a remote commander.
 

·
Registered
Joined
·
253 Posts
sounds like the on-board "remote" is failing... i have two RM-PJ1292 remotes available. same as the RM-1271 with the addition of one button for electromagnetic focus for the 1292. 150.00 each plus shipping. thanks, ken
 

·
Registered
Joined
·
3,480 Posts
I have taken remotes and telephones apart before to fix the buttons. Sometimes a little moister gets in there. Use a cue tip to clean the rubber pad and the contact. The contact I think is like a resistor with carbon on it so do not rub this material off.


Deron
 

·
Registered
Joined
·
18,507 Posts
I use a good old Q tip with control cleaner. Seems to work fine.


Curt
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top