AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2,284 Posts
Discussion Starter #1
Hi folks


I figured i can try asking in here, since I didn't manage to solve the red convergence issues after an all nighter of changing settings


i have included a picture...but te bulk of the problem is red not converging....


i haven't done a banged up job my first time around...i am getting more adept at this barco menu


The only thing that i did to the uploads was to compress it my 80percent....i would think correcting anything with photoshop would defeat the purpose for this thread


thanks for any posts in advance



Martin
 

·
Registered
Joined
·
18,501 Posts
Pix # 2 shows red squiggles. THat's a bad convergence board, and I can fix that. It's a ***** to fix, I can't point you to a specific part.


It looks also like your V shift pot on the red is off, pls refere to my website www.curtpalme.com in the BArco 800 tech tips section on the location of that trimpot.


BEfore you tweak, reset all raster shifts in the installation and convergence menu to 50%.


Curt
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top