AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,363 Posts
Discussion Starter · #1 ·
Just a quick note as I am not seeing something properly.


How do I know which controls (being set by CalMan) in using the Lumagen are for the Primaries or Secondaries?


Which are the proper controls to use/measure? I am just trying to confirm the proper patterns and controls in using the Lumagen with/without CalMan. Am much more familiar with HCFR.


Thanks


(Hope I am expressing myself properly. Have spent some time with a beta of some new software and think I am going blind from too many trips in and out of darkness)
 

·
Registered
Joined
·
2,028 Posts
I don't understand your question......

The controls for Gamut management are in the Colour Management part of the OUTPUT config settings on the Radiance. You can either adjust them by colour or by sticking values direct in to the MATRIX.


Use 75% stimulus and 100%stimulus colour windows. I tend to check with small windows and FULL screen to see if there is any difference in how the display reacts
 
1 - 2 of 2 Posts
Top