AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1,745 Posts
Discussion Starter · #1 ·
It would really help if I could shift the raster vertically but there appear to be no hard or software adjustments I can find. Yet if I look at the schematic it says there is a green shift input feeding the op amp to the green output stag. So I am optomistic about it. I am hoping I just haven't found it in the menue somewhere yet. All I have is the schematics, I do not have an owners manual.


Red and blue are no problem, because both of those have clearly identified pots on the v-board and they adjust well.


Unfortunately this projector does not have a converge on green card either.


Appreciate any help or suggestions.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top