AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
86 Posts
Discussion Starter · #1 ·
I'm trying to send a SD signal over RG6 to a monitor that only has DVI and VGA inputs. Anyway to accomplish this cheaply (it's VERY temporary)?


TIA,

Richard
 

·
Registered
Joined
·
428 Posts
If your SD source is composite video...


Terminate the RG6 with RCA plugs, run the composite down the RG6, use a composite to VGA transcoder, and input into the VGA port. As far as cost, we have a piece that will do the transcoding, and with that, you're looking at about $300 bucks.


Trent
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top