AVS Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Hello fellow screen owners,


I just recently purchased and install FAVI HD-120 screen - when it is closed, a part of the screen is still hanging out (black area). I would like to make sure it completely closes - so I tried to follow their instruction and it is as misleading as it can be.


I only see three holes on the metal housing - one on the front (right side), and two on the right side, but when I put the yellow plastic "screwdriver" they provide - i can't find where it goes, it just roams freely inside.


Any help would be greatly appreciated!

Thanks!

Eugene
 

·
Registered
Joined
·
1 Posts
only one of the adjustment screws are in the holes in the casing. with the screen closed look in the gap between the screen and the casing on the power side to see the other screw. they are both on the bottom
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top