AVS Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
Never mind! Fixed it!


Hi,


I ran the channel setting (Antenna) on my Magnavox ZV450MW8A but when it's done, only 1 channel seems to be memorized. When I click on the (+) channel, E1 (Rear) appears, when I click again, E2 (Front) shows up, the third click poduces the only channel again. Entering a channel number results in a blank screen. I went exactly by the manual but I must be doing something wrong.


All channels are perfectly fine on TV (looped through the Magnavox).


Can someone help?
 

·
Registered
Joined
·
20 Posts
Discussion Starter · #3 ·
Well, I have a pretty elaborate cable setup in my house and I had mixed up two cables. What threw me off was the fact that my TV worked fine although it was connected through the Magnavox.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top