AVS Forum banner
Not open for further replies.
1 - 1 of 1 Posts

· Registered
4,525 Posts
Discussion Starter · #1 ·
Maybe you guys can help me out...

I have a 2 channel amp. that I would like to use to run 2 tactile transducers from my Subwoofer 2 LFE channel.

Is there an inexpensive way to balance these with the rest of the system? Ideally, I would like to have them -6 db down from the sub. I have an SPL meter for the calibration, but no way to control the transducers without controlling the sub.

Is there a real simple "set it and forget it" volume control that can be plugged into one end of the cable that will do this for me?

PS - I am not an electronics DIY...I would rather buy this than build it.



Mark Hunter
1 - 1 of 1 Posts
Not open for further replies.