AVS Forum banner
1 - 3 of 3 Posts

· Registered
2,803 Posts
Discussion Starter · #1 ·
I have Shark007 codecs installed on my machine. I recently ran the deinterlace test demo video and noticed my set wasn't passing the test.

I then learned the codecs have to be "set up" properly. Opened them up, low and behold, there are a million and one radio buttons and various options that look to be duplicate.

There are several tabs and I'm not sure how each of these should be set up.

For example, I was told I should use DXVA and Haali's splitter. I set those in all the tabs to be the ones used, went back to retest, no change.

It would be nice to know I'm flipping the correct switches.

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.