AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter · #1 ·
Hello all!


I'm new here and I'm hoping some of the knowledgable people of this board can answer a question for me.


I'm about to purchase a Sony VPL HS-10 and I'm just wondering if you can connect two sets of component cables to it by hooking one set directly into the projector and the second into the included multi-in cable.


Obviously one can physically do this, but I'm wondering if I can switch between the two inputs and avoid having to get a seperate component switchbox other than the two inputs on my pre/pro.


Thanks for any info anyone can provide!


Rob H.
 

·
Registered
Joined
·
290 Posts
Quote:
Originally posted by Rob_Hutchinson
... if you can connect two sets of component cables to it by hooking one set directly into the projector and the second into the included multi-in cable. ... if I can switch between the two inputs ...
Hi and welcome.


This one of those questions that only require a one word answer.


Yes, to both. Although switching inputs is a bit tedious due to having to cycle through the inputs. A little trick I use is using the discrete input select to select the MS (Memory Stick) input then go forward from there. Hopefully you will get what I mean once you get your pj.


Not bad for a one word answer! :D
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top