AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
5,532 Posts
Discussion Starter · #1 ·
Question...I have to stack my components and was thinking about air-flow, I have a Dish network 811 soon to be 942 and PureAv line conditioner a DVD player that will be stack onto each other...is this going to be a problem...is there some sort of feet I can buy to raise these components...I figured if I raised each unit they would run cooler...Thanks in advance.
 

·
Registered
Joined
·
1,856 Posts
You can buy rubber feet at Rat Shack. As long as there is some air flow, I wouldn't suspect there to be too much of an issue with the components you're talking about, none of them should run very hot to begin with. I wouldn't include an amp or receiver in that stack though, as they do require sufficient space for cooling, and are far to heavy to be on top of the other pieces you referred to.
 

·
Registered
Joined
·
5,532 Posts
Discussion Starter · #3 ·
Actually the Dish network 811 gets quite hot...I guess a run to RS might be a good option...I would like to raise them 5/8 of a inch...Thanks
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top