AVS Forum banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
111 Posts
Discussion Starter · #1 ·
I have a Mitsubishi XD300 pj. It doesnt have the "standard? component in jack. It has a 15 pin component in. I purchased the correct cableing an all that.


It seems that I cannot change the brightness and contrast settings when using this input. Also, it seems as though the FJ chip is being bypassed (the option is blacked out when I am on that input)


Is it common on PJs with a 15 pin comp in for this to happen?
 

·
Registered
Joined
·
2,537 Posts
Actually we have lots of different projectors, just not too many Mits.


I know on my Panasonic LC76, I can adjust colour and saturation with component in, but not individual Red/Green/Blue levels. It is a 'feature" of the firmware. May be something similar onthe Mits.
 

·
Registered
Joined
·
65 Posts
What is faroudja for than - for s-video in only.

See if there is an input selection for vga. I believe XD300U has two seperate 15 pin inputs - one is vga only, second is VGA/Component try this one - should help, see the manual.


Let us know what is your overall experience with this pj - PQ, colors etc.


I would like very much to hear about it as it may be my pick for HT assuming all the options and bells and whistles are working as advertized on this unit.


Cheers,

mike
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top