AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have been unable to get my Replay 5040 to work properly with my Sony WEGA TV when I try using the component output. I get a bunch of vertical broken lines. Has anyone else had this problem? My 5040 in the living room uses the component output with my Mitsubishi HDTV without any problems. I have verified the cable and the component output and input on both the TV and the Replay.
 

·
Registered
Joined
·
253 Posts
The Replay 5000 series of units only works with PROGRESSIVE component inputs.


That's why it's working with your Mitsubishi HDTV and not your WEGA. I would verify that your WEGA supports progressive scan sources.
 

·
Registered
Joined
·
83 Posts
This has been covered in this forum many times. Your TV must be able to display progressive scan images. Lots of the older Wegas only display component video in 480i (interlaced) format. The ReplayTV outputs 480p (progressive). If you have one of the lower-end Wegas then S-Video is the best you can use.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top