AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter · #1 ·
Is there any way to hook up your computer to the Mitsubishi WS-55805 via the RGB input? If so what equipment do you need? I noticed the RGB input on the TV is different than the I thought it was possible but couldn't find any information.


Thanks in advance.


BE
 

·
Registered
Joined
·
957 Posts
go do a search on the HTPC area. I have the same set you do and have done it a couple of ways. Depends on your HD set top box. I used a DTC100 and a Altinex DA1916SX which worked great with the two VGA sources (DTC100 and PC) connected to the TV with a breakout cable. Now I have a Mitsubishi SRHD5 and TUDST50 which have component outputs. I run the PC through a Audio Authority 9A60 to add a third component input. All three sources are then run through a Extron SW4AR (300+MHZ bandwidth and switches four sources) This works great for me. you can buy most of these expensive switches for pennies on the dollar on Ebay if you work it right.


Good Luck


Rick


------------------

RJW


[This message has been edited by wezar (edited 10-07-2001).]
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top