AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
Hello everyone


I have a runco idp900 that has a small female connector with one red and one blue wire connected to it. I am thinking that it connects to the idp interface board located just under the top cover above the green lens. This board has two spots where this could connect to, one is labeled jumper 3 and the other is jumper 5. If any of you are familiar with this projector and know the wire I am talking about please let me know. There is also a flat grey computer style cable that is not connected to anything either and I was wondering if that also should be hooked up.


thanks Jamie
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top