AVS Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello

I have noticed on my amp that on the back there is a remote in and out jack.
I was wondering if there was a way to connect an arduino uno directly to this jack to control the power and volume of the amp as I am trying to translate a ps3 bluray remote amp codes to work with my amp but if I just re-emit via an led the signal doesnt get through properly as the ps3 remote is blinding the sensor on the amp. As I have the amp in the center of my setup I would prefer not to stick an led to the front of it as it would look horrible. Does anyone know the language and pin out of this jack that I might be able to try and attempt to use to control the most basic functions of the amp.

Thanks
 

Attachments

1 - 2 of 2 Posts
Top