AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
3,858 Posts
Discussion Starter · #1 ·
I just got an Extron SW4 AR off of Ebay, because I need a switch box for all of my componnent cables. I didn't realize that the thing takes BNC instead of component cables. Is there any way to convert it from BNC to Component? If not then I bought this thing for nothing.


------------------

STOP DVI/HDCP!!!!!
 

·
Registered
Joined
·
887 Posts
What goes through the cable is not constrained by the connector. You can get BNC to RCA (phono) type adaptors since I assume your "component" cables have those and you should be fine. BNC are sturdier and "lock" so they don't accidentally get disconnected and that's why they're preferred in "pro" rather than consumer units. They're both good for hooking coaxial cables...


Don't worry, be happy , watch HD


AJ
 

·
Registered
Joined
·
3,858 Posts
Discussion Starter · #4 ·
Thanx for the info!


------------------

STOP DVI/HDCP!!!!!
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top