AVS Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
Hi,


I want to know what conf is better to get maximum specs of my nec xg 1351LC.


DVDO VP-20 (connected via HDMI) + Moome HDMI 1.3 expansion card for my nec


DVDO VP-30, 50 or 50 PRO (connected via BNC-RGBHV)


What of these solutions will be better for my nec?? excluding prize only vision quality


Also other better configurations will be take in consideration.


Thank You
 

·
Registered
Joined
·
4,355 Posts
Id get the Moome MUX-Hd , it will take care of HDCP issues and then you can use the Vp 50 to output 1080p to your NEC via RGBHV. I use the Lumagen though on A marquee CRT projector.


Athanasios
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #4 ·
I discard lumagen because his output dvi-d don't fit to my tv (hdmi yes but no dvi-d), and I though that this would be almost the same quality.


If you think that it's the best option i can think about and look dvi-d-hdmi conversors.


I put best option to worst option ( I think):


1. Lumagen (version??)

¿?2. DVDO VP-20 (connected via HDMI) + Moome HDMI 1.3 expansion card for my nec

¿?3. DVDO VP-30, 50 or 50 PRO (connected via BNC-RGBHV)
 

·
Registered
Joined
·
4,355 Posts
Id still get eh MUX-HD out to the lumagen , the MUX has two outputs one HDMI and one DVI they are both on at the same time so you can run two displays if you want.

http://www.curtpalme.com/MUX-HD.shtm




then run that into your choice of VP(lumagen is better i think, the gamma control at 11 points is the clincher for me!! ) and out RGBHV to your NEC.


Athanasios
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top