AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I hope someone can help me with this. I recently had a third receiver and a new cable from the dish to the house installed. I can't receive all the channels on them. I went into the dish setup to test signal strength. On the 119 transponder 22 it says dish pointing mismatch on 101. So I must be getting the 101 on the 119? They did install a three way splitter also. I did notice when I tune to Fox News, that the other two receivers do work then. I also tried resetting and removing the access card. It didn't work. Any help before I call D' would be appreciated.
 

·
Premium Member
Joined
·
7,093 Posts
Take out the splitter and go directly to the dish from each receiver or install a 4x or 5x multiswitch with all 4 inputs connected to the dish instead of the splitter. You can't split lines to get more receivers. Each line carries a signal from the receiver as well as to the receiver and 2 or more receivers sending different signals over the same line just won't work.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top