AVS Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
722 Posts
Discussion Starter · #1 ·
I was messing around with the fine tuning setup and apparantly left the IR code at 4476. Now the remote won't move the RTV. How can i reset the code.


There is another issue with a different RTV, a Showstopper, where the STB isn't moving channels as well. I think the blastr is attached correctly. Is it possible the plug port is blown out?
 

·
Registered
Joined
·
107 Posts
nobody?


1. RTVrc is a remote control program you run on your PC to operate the RTV over ethernet. and view its menu.


2. DVArchive also has a RTV remote control feature but you can't view the RTV menu.


Enter-key will be a problem.
 

·
Registered
Joined
·
722 Posts
Discussion Starter · #3 ·
Thanks for the clue. I did get both RTVs working a few days ago. The Showstopper was a real pain, though. It didn't want to accept fine tuning options no matter how many times I tried changing them. Finally, it did and I've been holding my breath since.


It's good to know about RTVrc and I'll keep it in mind for future use, DVA too.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top