AVS Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 · (Edited)
as of the post ther all out of stock but when ther in whick would be the best woof for the buck
currently plan to drive via my xls 1502 in a ported 3.8cft cab tuned to 18hz in winisd iv modeled all three for my cab design only the fi's need any eq to flat out the fq curve

cab design has a planed 45in long 12in wide by 2.5 flair port

3156695


3156696


3156697


3156698


3156700


this would be a layered mdf cab with front an back panels 1.5in thick an port wall 1.75in thick out an outer sides 2in thick with an inner dim of 30in by 16.74in by 12in

counting the space before port entrie is 16.74in 12in by 5.5in this give a totel net air factoring driver displacement of all three driver options of 3.755 cft3 to 3.85cft3

the cabs outer would be 38in h by 15in d by 24in w

the planed port postion in downward placed on a 6in custom attached stand from mdf scrap with a 1.5in foot with a .5in rubber pad

3156717


3156718


the cabs would be mirrored to either side of my ht room an 1in out from the wall



to winisd models an wdr files
 

·
Registered
Joined
·
4,718 Posts
when ther in whick would be the best woof for the buck
IMO, that's up to you to decide. Also, not sure about the decision to load a driver that's intended for IB into a very small ported cab :unsure:
It would also be helpful if you'd post your WINISD models.
 

·
Registered
Joined
·
20,016 Posts
Forget the IB driver, although the best of the bunch IMHO, not recommended for anything other than IB, I tried.
 

·
Registered
Joined
·
4,718 Posts
IB=Infinite Baffle
 

·
Registered
Joined
·
63 Posts
Discussion Starter · #6 ·
IMO, that's up to you to decide. Also, not sure about the decision to load a driver that's intended for IB into a very small ported cab :unsure:
It would also be helpful if you'd post your WINISD models.

to winisd models an wdr files
 
1 - 7 of 7 Posts
Top