AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
395 Posts
Discussion Starter · #1 ·
Alright, I'm pretty confused now. Can anyone tell me why if I connect my HTPC via DVI / HDMI cable to my 55 rear projection Sony TV via the HDMI input it works fine, but if I connect it to my Sanyo PLV-700 (1080HD) lcd projector via it's HDMI input, I don't get a signal.



Any help !!!???


Thanks
 

·
Registered
Joined
·
516 Posts
It could be that the mode that the PC is sending to the projector is not supported by it. Does your graphics card have two outputs? If it does you could connect the TV and projector at the same time and change the output mode to the projector until you get a working resolution.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top