AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
I just bought myself a 55"x3yards RP screen that I now need to attach to the frame I built out of anodized conduits, much like in the following link:
http://outdoormoviescreen.blogspot.com/


Now since Id like the screen to remain closer to a 16x9 ratio than to a 2.35:1 ratio, I'd like to use a different way of attaching the screen to the frame than the one proposed.


Whichever method you can propose should allow for a quick setup (I'd like the screen to remain transportable/easy and quick to setup)


So far I tought about using grommets or sewing some band of tissue on the side to allow the tubing to fit in these band of tissue. Any positive/negative comments on these approach?


I did a few search but I guess I didnt used the good keywords


Thanks


Benoit
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top