AVS Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
109 Posts
Discussion Starter #1
I am mounting my PJ through a drop ceiling and cutting a circle for the bracket/pole to come down through. Any suggestions on how to make the hole look nicer than just a circle saw cut? I was thinking using a recessed lighting baffle like the one posted below, looking for other thoughts/suggestions.
 

Attachments

·
Registered
Joined
·
109 Posts
Discussion Starter #4
the down pole should just about fit in the bottom part of a 2 inch desk hole grommet, You would need to verify



I like this idea as it is a smaller circle, but not sure if there is anything that could secure the inserted part? Usually these just sit in desks to gravity but if I insert so the 'trim' part is facing down it may just fall I'm thinking?
 
1 - 6 of 6 Posts
Top