AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi all. I decided to take the HD plunge this morning, and picked up an RCA DTC-100. I connected my cable to ANT-A, OTA Antenna to ANT-B and my other LNB to the Sattelite antenna. I first checked the box out via the SVideo connector, and all was fine. I then connected the DTC-100 to the RCA Transcoder via VGA and plugged the Y PR PB cables to Component-2 on the 46807. When I press the HD monitor on the DTC-100, the screen on the component input changes from black to blue, but I get no picture. I know the connector works, since that is the one I originally had my iscan pro hooked up to (I moved that to Component-1). Is there anything else I need to do to get the 1080 signal to show up?

-Michael

 

·
Banned
Joined
·
3,772 Posts
Sounds like you have it all figured out.


You should be able to gets some menus (using the remote)

even if you are not receiving a signal.


Note: The DTC100 outputs 540p unless you are receiving an HDTV source, so perhaps your transcoder or display has a problem with 540p???


If you have subscribed to DirecTV HBO you can try that on channel 509 for 1080i.

 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top