AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
928 Posts
Discussion Starter · #1 ·
There is a gray-scale ramp in chapter 12 (I think) that has two white bars running horizontally on top then there are two black bars ruining horizontally at the bottom with 2 blended gray-scale bars in the middle. Does anyone know how to use this? If the point is to make the two top bars totally white (by upping contrast) and the two bottom bars just pure black(By lowering brightness) then this leaves my settings way different then the other gray-scale ramp - (the ramp that go up in 5% notches that puts me at 48 Contrast and 56 brightness) while the one I'm talking about here puts me at 60 contrast and 48 Brightness ( which I like a ton better) but according to the brightness scale with 0% and 2% and 4% it crushes them all and I can't even see 4% above black. Just wondering if anyone know how to use this gray-scale, the disk said it's for lamp based projectors. Anyone? david
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top