AVS Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I’m having trouble with my Electrohome ECP-3500. The top right hand corner of the screen is squashed so that the difference in height between the top left and the top right of the image is a good few cm’s. Where the image should be reaching up too in the far top right corner is a slight white fuzz about 2cm long. This suggests to me that it isn’t a conversion issue and seems to be a distortion. The full image is displayed, it just appears squashed on that side.


Any ideas as to what the problem could be?
 

·
Registered
Joined
·
6,126 Posts
Did this problem just start or is this a new installation? If it is a new installation, I would say that the projector is not square to the screen. If this is the same for all three guns and the unit is floor mounted, push it to the left a couple of inches and try it again.


Chip S.
 

·
Registered
Joined
·
3,557 Posts
Use the search engine to pull up a wealth of info on setting up ECP's. I suspect you need to do a hard reset and start from scratch. Again, this and other procedures are easily found using the forum's search feature.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top