AVS Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I'm wonderig if anyone can provide some advice on a Marquee 8000. The red goes in and out while using the projector. It usually flickers on and off after about 30 minutes of viewing. Sometimes it comes back on and other times it stays off. It will usually come back on if I turn the projetor off and back on again. I have verified that the problem is not related to the input source. Are there common problems that I could look at? Maybe even something loose?


Thanks,

McFarland, WI
 

·
Registered
Joined
·
4,801 Posts
Hello


Sounds like a tarnished connection; get some denatured alcohol and a tooth brish and clean the coaxial cable sockets on top of the VIM input section and the ends of the cables also; repeat that cleaning at the neckboard end. Make sure the G2 jumper at the neckboard is snug onto the pin at the tube socket.
 
1 - 2 of 2 Posts
Top