AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
138 Posts
Discussion Starter · #1 ·
atm moment i have an error code which states that the "(H stop)115v down" is gone and the "HV over" is gone.


firstly i had the error 2 code which is just the "H stop".but now it must have wrecked something else.


another problem i had is where the green tube didnt focus right.i have to keep a nail(or anything metal) on the focus yoke to keep tight focus or otherwise its blurry.this was when error code 2 ocurred i think but i didnt take much notice.


we took the power supply out it seems there is nothing obvious wrong with it.but there could be a board underneath the tubes where a solder point has blown?


does anyone out there know what exactly the problem is?
 

·
Registered
Joined
·
138 Posts
Discussion Starter · #2 ·
anyone?
 

·
Registered
Joined
·
385 Posts
I had the same problem on my 1292....turned out I had to replace the Horizontal deflection board. After that it worked fine. I got my board at CRTCinema.com


~Ryan
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top