AVS Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
211 Posts
Discussion Starter · #1 ·
I can't seem to get them right Any one have the download file? SI 18 D2


lol forgot to mention what driver
 

·
Banned
Joined
·
15,491 Posts
You're putting in too much information. Only enter Qes, Qms, Fs, Vas, Mms, Re, xmax and Pe, let the program calculate the rest.
 

·
Registered
Joined
·
444 Posts

Quote:
Originally Posted by deathinc  /t/1468449/error-message-when-entering-ts-parameters-in-winisd-pro#post_23208051


I can't seem to get them right Any one have the download file?

For what driver?


First enter Mms, then Fs. Click on Cms then Fs again. Enter Sd, Bl, and Re. Enter Qms and click on Rms then Qms again. Enter Xmax and Pe. Save file.
 

·
Banned
Joined
·
15,491 Posts

Quote:
Originally Posted by cookieattk  /t/1468449/error-message-when-entering-ts-parameters-in-winisd-pro#post_23208223


it also errors if u enter qes and qms as the same value
As it should, since it's virtually impossible for those figures to be the same.
 

·
Registered
Joined
·
444 Posts

Stereo Integrity SI 18HT D2_Data Bass.zip 1k .zip file


I used the TSp's from Data Bass. iirc, these were the specs most guys were using early on in the SI pre-order thread, but you should verify yourself.
 

Attachments

1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top