AVS Forum banner
1 - 2 of 2 Posts

· Registered
66 Posts
Discussion Starter · #1 ·

I need some help with setting up my new Europower EP2500 amp in regards to the Mode Switches. Here is what I have. I am running a Yamaha RX V2600 receiver using my sub output going into the balanced XCR input channel one of the EP2500. From their I am running two Tempest X subs. I need to know what the Mode switches need to be set at. Can anyone help me out?

Thanks Rick
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.