AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
After reading MR Wiggles post on 'RGBHV sucess on shielded Cat5'. http://www.avsforum.com/ubb/Forum10/HTML/006683.html

I had an idea about doing the same thing with an EVC plug on one end. As I'm no engineer could someone explain if this could be possible and if so a basic outline of how it would be done? It's to be used with my Davi DL450 clone.

I've read previous post about using the EVC-VGA adapter but thought this might be easier and a bit lighter on the wallet. http://www.avsforum.com/ubb/smile.gif


Thanks Dale Williams


------------------

Patience is a virtue of a lonely man.


[This message has been edited by Snail'D (edited 06-26-2001).]
 

·
Registered
Joined
·
1,098 Posts
You could do this for the EVC plug as well. I have posted the pin-outs and EVC-VGA mappings at various times. Look for posting by 'gireesh'. 'clopez' may know where to buy the EVC male plug that you will need at the projector end.


Gireesh.


------------------

Stop DFAST
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top