AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
4,916 Posts
Yes you can. It's 5 chips. Let me know and I will trade you 1.01 (which has G2) for your 1.10.


Terry
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #3 ·
I have programmed 5 new EProms with 1.03 Firmware. Then, I changed the EProms on YA and YB-Board. I switched S400 to "Table".

Normally, if you power the Projector up, you see the following Codes in the Display: 68 ---> 7 ---> 12 ---> 14 ---> 16 ---> 60. Then, you power up, and its ok.

I see only this in my Display: 68 ---> 7 ---> 60, powercyle, and nothing goes. :(

I think that you can only upgrade, but not downgrade.


Regards,


Joerg
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top