AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
154 Posts
Discussion Starter · #1 ·
I have a question about the In/Out setup of the AVR.


With each device, you MUST choose a component video intput. There is no "none" selection. So say for Video One, I renamed that to ReplayTV (since the remote is labeled VCR). I have audio going in optical 3 and S-Video in Video 1 in the back. I have transcoding on (or whatever their fancy name is on the OSD, and set to AUTO). There are no component cables being used with the device. But if I were to leave it at the default Component 1 setting, it'd interfere with my X-Box. In fact, I tried this and sure enough, with both devices on, my X-Box displayed on the screen. The other choices for Component are Component 2 and DVD.


So what I did to get around this was set all my S-Video or Composite devices to Component 2 since nothing is plugged in there. Then it automatically used composite or s-video as needed.


What if I end up with a third component device and fill all the slots (Component 1, 2, DVD)? Then when I ran setup, I would be forced to choose an active one and it would end up showing me the wrong output for a particular device.
 

·
Registered
Joined
·
154 Posts
Discussion Starter · #2 ·
Bump. I'd really like an answer if someone would help me out?
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top