AVS Forum banner
1 - 2 of 2 Posts

3 Posts
Discussion Starter · #1 ·
Hello everyone

I mounted a front projector an a wall and have all the wires running up inside the wall. As well I added a plug on the wall behind the projector.

What I am not to sure what to do is make the wires look a little better when they come out of the wall and go into the wall. Basically I have a hole on the lower level at the baseboard height and then a hole behind the projector and Bluray player. What options would I have to clean this up? Any ideas I am just doing renovations so this is the time to do it.

Thanks in advance

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.