The manual says to turn until led goes off. Can someone be very specific and tell me where this led is located. Is it inside the projector, outside the projector, inside the tube, etc etc. I can't seem to locate the leds, thanks. Oh, if it's in the projector, I know I need to remove the cover, but do I need to flip the circuit board open too, thanks.
G2 adjustment for Barco Cine7
- Status
1 - 2 of 2 Posts
Hi tanwn
I have a Barco 708 which I think is similar, my G2 lights are green neons, which are on the board just under the green CRT,
Take cover off, release swing down board assembly, just under the crt at the back , they are named in small white writing.
I have taken a picture.
Steve
![]()
I have a Barco 708 which I think is similar, my G2 lights are green neons, which are on the board just under the green CRT,
Take cover off, release swing down board assembly, just under the crt at the back , they are named in small white writing.
I have taken a picture.
Steve
1 - 2 of 2 Posts
- Status
Join the discussion
Join now to ask and comment!