AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
124 Posts
Discussion Starter · #1 ·
i was about to make the adjustments found on: http://www2.dgsys.com/~jchill/barco/g2.html


when i felt a little unsure what pots.. But as i only can see 3 (r,g,b coloured) i guess it must be them.. right?



Second:


When squeezing the image to 16:9 format, i can see the retrace lines very

brightly at the top of the screen, and they don't move so i guess they would burn-in quickly. How do i get rid of them? Blanking dos not work on them.


Third:


Soem of the convergence adjustments is very high in the 70-90 range

( i have done resetting and everything else), this is a table mounted right now, but is to placed ceiling soon. Is it true that the pj is supposed to be ceiling for the best convegence ? Will i get closer to normal settings when i do?


TIA


/Anders
 

·
Registered
Joined
·
4,916 Posts
TIA,


The G-2 adjustment pots are located on the PS/Diagnostic board which is the far right board when viewing the projector from the top and rear. They are colored R G & B.


Terry
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top