AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello,


Does anyone know where i can find the G2 pots on my Barco 1209?

The PJ doesn't display real black (even when bright-setting is 0) :(


Thanks, Pierre
 

·
Registered
Joined
·
476 Posts
Hello Piere


If you stand behind the projector and open it the G2 controls are on the right side on the board with all the led's


Rob
 

·
Registered
Joined
·
476 Posts
Hello piere


Open up the middle of the projector you see on the end of each tube a black box on top of the black box is a small hole with 2 pins where you can put a jumper on

Do that on all 3 colors

Set the projector on 6500k and set cut off red and bleu to 50 brightness to 50 and contrast to 0

Put on a black signal rotate the button and look inside the lens turn the knobs till the raster is just visible on all 3 colors

Remove the jumpers and the G2 controls are set


Rob
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top