AVS Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,195 Posts
Discussion Starter · #1 ·
Ran into a problem when calibrating levels with my Xonar, I noticed that my rear channels are running at almost same levels when a tone is sent to each level. Well one is actually a bit quieter by about 10dB but sound comes out of both LR when playing a tone through R and vice versa.


I have verified its nothing else in the signal chain by switching the out the rca's on my amps for the surrounds to the fronts and it still does the same thing so the amp is not the issue. Since I am only running analog outs the Xonar seems to be the issue.


Ac3filter reports that sound is only going to a respective channel but both channels are active.

http://www.avsforum.com/avs-vb/showthread.php?t=742969


I am using this DVD to calibrate everything.



So is my card broken then? It also cross talks with the windows test tones in the mixer.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top