AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter · #1 ·
I am trying to use Girder to change the channel on a television by sending three commands, one for each number. I made the three number commands that each work individually then copied them into a multigroup in the correct order. When I run the multigroup Girder only send the first number. Anyone have any ideas why?


Thanks.
 

·
Registered
Joined
·
599 Posts
Quote:
Originally posted by doublek
When I run the multigroup Girder only send the first number. Anyone have any ideas why?


Thanks.
I don't know what transmitter you're using, but I believe your problem is likely that you do not have any spacing between each IR transmission. Try putting a 'Wait' in between each number in your multigroup. Start with something ridiculously big (like 2000 == 2 seconds) and get it working and then reduce to find where it still reliably works to.


-Jon
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top