AVS Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
4,018 Posts
Discussion Starter · #1 ·
Ok.... it's MY turn to yell for help.


I have a GP3000 I recently picked up for a song. NO burn whatsoever. Bright as blazes. Only trouble is that the top right corner blue convergence is severely distorted, and will not respond to normal or point adjustments sufficiently to bring it into range. It's only the top right corner, about 4x4 squares or so in the test pattern. I am scratching my head on this one. The unit appears that it has very few hours on it, as it's SPOTLESS. Hmmmmm......


I don't have a manual for this one.... It is set for front, floor projection. Are there any plugs for changing the polarity for the alignment coils? I don't see the usual plugs, only the ones for the yoke, and they are correct.


Thanks


Marc
 

·
Registered
Joined
·
567 Posts
I know im stating the obvious.. but i assume the raster is nicely centred on the blue tube, is it?
 

·
Registered
Joined
·
4,018 Posts
Discussion Starter · #3 ·
YYYYYep. :)
 

·
Registered
Joined
·
567 Posts
Does it only occur on the internal test pattern? Or is it present on external video sources as well?
 

·
Registered
Joined
·
4,018 Posts
Discussion Starter · #5 ·
YYYYYep.... both :)


Just got off the phone with Doug.... going to try a few things tomorrow.


Hehe... let's see you make THIS look better. :)


Marc
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top