AVS Forum banner
Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter · #1 ·
I just moved my old Barco 1600 that I don't use any more and was going to install it at another location. First I just converged it fast using the internal patterns and then I inserted AVIA. Everything looked very strange. In the menues I had red shadows and all white things looked pinkish. After checking the tubes and just showing one crt at the time I could see that it was acctually the green that looked strange. The image was terrible.

Then I changed to S-video and everything looked perfect. So it isn't the green tube itself but something else.

What could have gone wrong when I moved it? What is the diffrence when using S-video and RGBHV?
 

·
Registered
Joined
·
767 Posts
Re-seat your boards and connectors...


Marc
 

·
Registered
Joined
·
3,137 Posts
I have the same problem with my BD701.....but the red tube instead. Not

many boards to reseat:)


I'm going crazy. I'm even thinking of getting a RGB to component converter,

so I can get it running....And we don't use component in Denmark.


Nich
 

·
Registered
Joined
·
968 Posts
Probably the only board it could be since s-video is working, is the rgb input & switch board. However, I suppose you could just as easily just have the green BNC connector swapped with red or blue or something like that.


Mark
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top