Green line through middle of screen???

*bump*

Sounds like a convergence board issue. See if you can back off on one of the controls to get rid of it.


I've got a couple here that are doing that as well, just no time to dive into them yet to see what the scoop is with them.


Curt

I got this on a couple of Sonys, it had something to do with the red and blue top and bottom Keystone 'balance'? It was a long time ago but it was one of the pots that balance or combine the red and blue. Doug

I'm kind of a rookie guys, could you go into a little more detail for me?

Im a rookie also on Sony, can someone help him or do a take off. Thanks, Doug

Simple. Tweak each convergence pot slightly with a freeze frame from a DVD showing the fault clearly. See if one pot adjustment makes it better/worse, and see if backing the control off from where it is eliminates the issue.


One of these fine days (Xmas?) I'll dive into these dead convergence boards here and find a permanent cure for this, unfortunately it's a low priority right now.


Curt

By convergence pots you mean the adjustments used for calibrating/focusing the image?

Yes, sorry, what you said..


Curt

I'm not having much luck getting rid of the line. Which dials exactly should I be messing with?

could it be an input problem? ground or something? I saw something similar with my old Barco, and every now and then it is faintly visible in my NEC - making me thing it is something in my setup, before the pj, rather than my butchering of pj settings causing the problem. possible?

Nah, I haven't been fiddling around inside it or anything.