AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,052 Posts
Discussion Starter · #1 ·
I use an older Harmony 670. I just bought a new DVD player (Panasonic BD85). I haven't used the Harmony software in awhile so when I plugged the remote in it did a software upgrade on my PC to the latest version. I went through the setup for the new DVD player. It indicated there was no exact match and needed to learn a couple settings from the original remote. All went well and it downloaded all new commands into my remote however, when the software goes back to the start page for my system it still shows the DVD still needing setup. The remote appears to mostly have the new commands but I can't fine tune it because on the Device page it still says "set up now" and the "troubleshoot" and "learn IR" buttons are grayed out. What am I missing or doing wrong here?
 
1 - 2 of 2 Posts
Top