AVS Forum banner
1 - 2 of 2 Posts

109 Posts
Discussion Starter · #1 ·
I have an HTPC with a Hauppage HD PVR connected with the included IR blaster attached to a Directv H21-200 (HD Receiver).

I configured the blastcfg program by using the learning feature for using the Directv remote.

When using Windows Media Center, however, I can't change the channels appropriately. I am quite sure it has something to do with the settings in blastcfg (Blaster Configuration), but just can't figure this out

Any ideas what to put into the following settings?

1. Min. Digits to Send

2. Inter-Digit Delay (ms)

3. Power On Delay (ms)

4. Key Delay (ms)

5. Tuning Delay (ms)

6. Single Digit Delay (ms)

7. Send 'Power On' before Channel [Yes or No]

8. Send 'Enter' after Channel [Yes or No]

9. Use Major Minor Channel Format [Yes or No]

Thanks for any help!
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.