AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
99 Posts
Discussion Starter · #1 ·
Hi all, i just can't seem to access the factory and the service menus on my Z1.


I read a thread here that was saying about tweaking the service or factorey menu to improve the image etc and i want to have a play with it. They say to hold down input + select for 5 - 10 seconds, but i get nothing. Mine is a New Zealand model, but they all have the same model numbers so i doubt there is much change there. Do i have to have a signal going into it at the time? Any specific thing that has to be on/off for it to be accessed?


Also if people could post links to tweaks etc that would be GREAT!!


Cheers
 

·
Registered
Joined
·
68 Posts
Are you holding down the buttons that are directly on the PJ (that is, not the remote control)? Its a little tricky in that you have to press both at exactly the same time and hold for 5 seconds.
 

·
Registered
Joined
·
99 Posts
Discussion Starter · #3 ·
Yeah after i read someone elses post about it being tricky i tried a few times in a row and got it right.


Be keen to see other peoples setups and configs though.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top