AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1,128 Posts
Discussion Starter · #1 ·
I just upgraded my 466 celeron to a 933 mhz P3. But I can't run the machine any higher than 466.


MB is in jumper free mode. I have tried bios setting of 933 and 700, as well as using the manual setting with a 7.0x multiplier (as per asus instructions.)


It just hangs the machine when win2k loads. Any ideas?



thanks
 

·
Registered
Joined
·
127 Posts
Sounds like you may not have the voltage set high enough. What is it set to currently? Be careful increasing it though, only increase by the smallest increment and if it doesn't get any better after a small increase, don't go any further, as the problem may lie elsewhere.


Cheers
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top